Commissioning after engine overhaul
13
Pressurisation
It is extremely important for internal combustion engines (following the completion of repair work, i.e. in
their dry state) to be pressurised with lubricating oil before being recommissioned. This procedure can also
be used for ascertaining damage and its causes.
If engines are not pressurised, the risk of premature damage to bearing surfaces is very high because it
takes a relatively long period of time for the lubricating oil drawn in from the oil pan via the oil pump to
reach the individual bearings.
Such incipient damage need not necessarily lead to immediate bearing failure, but may impair the proper
functioning of the bearings and reduce their service lives.
Diagram of the oil flow with unpressurised engines
To Next Page
Loading...
Need help?
General
