Planning of engine installation
12
Additional information for planning the installation
In addition to this brochure there are several other documents that are required to plan the installation of
the engine that are not contained in this brochure. The scope of these documents depend on the delivery
scope and will be supplied by the MAN representative in the project stage.
Alternatively, these documents can be ordered through the following e−mail address:
marinemotor@de.man−mn.com
− Installation drawing
The installation drawing contains the important dimensions of the engine. It shows the dimensions of the
flywheel or flywheel housing for installing a coupling and for mounting the gearbox.
− Layout plan of the resilient engine mounts
The selection of the type and shore hardness of the resilient mounts depends on the setup of the drive
line (free−standing or flange mounted gearbox).
− Wiring diagrams
Wiring diagrams are available specially adapted for the needs of the shipyard.
Note:
The engines described in these installation instructions have the engine designations V8−1200 and
V12−1800. These engines are known at the factory under other model designations. These
designations may appear on drawings, layout plans, etc.
Comparison of the designations:
Model designation Internal designation
V8−1200 corresponds to D 2868 LE 433
V12−1800 corresponds to D 2862 LE 433
Information about commissioning and operation of the engines
The engines come with document folders containing the following brochures:
− Operating instructions 51.99493−8578
− Fluids and lubricants for MAN diesel engines 51.99589−8001
− Service board book (maintenance instructions) 51.99597−8027
These brochures must be carefully read before the engines are placed into commission.
To Next Page
Loading...
Need help?
General
