General
These instructions are provided to assist the qualified installer.
Check your local Yellow Pages for the name of the nearest
Manitowoc distributor, or call Manitowoc Ice, Inc. for information.
The ArcticPure
™
water filtration systems are designed to reduce
coarse and fine particulate matter from the incoming potable water
supply. Chlorine will be reduced in the water so as not to adversely
affect the ice produced or the equipment components. Siliphos
®
scale and corrosion inhibitor is automatically fed into the water to
inhibit the formation of scale on water solenoids and evaporator
plates. The NSF seal on these products is recognized worldwide as
a sign that the product to which it is affixed complies with the
public health requirements.
DO NOT install on line pressure above 125 psi (862 kPa).
DO NOT install on hot water line. Maximum temperature allowed is
100°F (38°C).
DO NOT install in direct sunlight.
DO NOT reverse connections. The system must be installed with
the inlet and outlet as labeled.
DO NOT install ArcticPure
™
filter systems in locations where they
can be damaged by other free-standing equipment.
PROTECT from freezing.
INSTALLATION must comply with existing state or local plumbing
codes.
This piece of equipment is made in America and has American sizes
on hardware. All metric conversions are approximate and vary in size.
Safety
Always follow these safety precautions when installing and
operating the water filter system:
DO NOT use a torch or other high temperature sources near filter
or cartridge.
DO NOT use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system.
Section 2
Installation Instructions
4Siliphos
®
is a registered trademark of Guilini Chemie GmbH
To Next Page
Loading...
Need help?
General
