Manitowoc QM45 Series Technician's Handbook

Part Number 80-01111-9 7/10 69
3. While components are soaking, use nylon brush
or cloth to sanitize the inside of ice bin. Sanitize
inside of door, door gasket, bin, top of evaporator
and evaporator bucket. Do not rinse sanitized
components.
4. Replace all components removed.
5. To start a sanitizing cycle, press the CLEAN
switch. The Clean light will energize to indicate
the sanitizing cycle has started.
6. Wait until the Clean light flashes (3 minutes) then
add 0.5 oz (15 ml) of Manitowoc sanitizer by lifting
the water shutter and pouring directly into the
spray area. The ice machine will automatically
time out a ten minute cleaning cycle, followed by
eight rinse cycles, and stop. The Clean light will
turn off to indicate the Cleaning cycle is
completed. This entire cycle lasts approximately
30 minutes.
NOTE: The ice machine will automatically continue from the
previous point before the clean cycle was initiated.
• If the ice machine was in the ice making cycle, the
control board will initiate a 2 minute harvest cycle,
perform the clean cycle and start ice making again
automatically.
• If the ice machine was in the off cycle, the control board
will perform a clean cycle and turn off automatically.
• If the ice machine was in a delay mode, the control board
will perform a clean cycle and resume the delay period
automatically.
REMOVAL OF PARTS FOR CLEANING AND
SANITIZING
1. Disconnect power to the ice machine at the
electric switch box.
2. Turn off the water supply to the ice machine at the
water service valve.
3. Remove the parts or components you want to
clean or sanitize:
! Warning
Disconnect el ectric po wer to the ice machine at
the electric switch box before proceeding.

Manitowoc QM45 Series Specifications

General

Brand	Manitowoc
Model	QM45 Series
Category	Ice Maker
Language	English