106 Part Number 80-1505-3 6/11
Water Inlet Valve
The water inlet valve normally does not require
removal for cleaning. Follow the instructions below to
determine if removal is necessary.
1. Set the ICE/OFF/CLEAN switch to OFF. Locate
the water inlet (in the water area of the ice
machine). It directs water into the water trough.
2. When the ice machine is off, the water inlet valve
must completely stop water flow into the machine.
Watch for water flow. If water flows, remove,
disassemble and clean the valve.
3. When the ice machine is on, the water inlet valve
must allow the proper water flow through it. Set
the toggle switch to ON. Watch for water flow into
the ice machine. If the water flow is slow or only
trickles into the ice machine, remove,
disassemble, and clean the valve.
Follow the procedure below to remove the water inlet
valve.
1. Remove the 1/4” hex head screws.
2. Remove, clean, and install the filter screen.
To Next Page
Loading...
Need help?
General