Part Number 80-1505-3 6/11 77
S1470C/S1870C/S2170C
A. Remove Splash Shields.
• Grasp the top center of splash shields.
• Lift up and then out.
B. Remove ice thickness probe.
• Compress the hinge pin on the top of the ice
thickness probe.
• Pivot the ice thickness probe to disengage
one pin then the other. The ice thickness
probe can be cleaned at this point without
complete removal. If complete removal is
desired, disconnect the ice thickness control
wiring from the control board.
To Next Page
Loading...
Need help?
General