MES1001H – EN
2. Shopping cart, you must screw the four supplied
screws.
3. Then adjust the height of the seat.
4. The last step is to adjust the front lighting.
CHARGING
CHARGING METHOD
1. Connect the charger is located at the front of the vehicle (see gure).
2. Connect the charger cable to the hole (make sure that the components are dry).
3. The charger light will light up in red during charging. When the color will change to
green, the battery is fully charged and you should disconnect the charger, otherwise
it will have a negative impact on the battery life.
4. Finish charging by covering the charging port, to protect it from moisture.
CHARGING SAFETY TIPS
If the battery will not charge at the right time, can cause damage. Full battery di-
scharge risk reduction of its viability.
Please use only original batteries, chargers and cables, it is necessary to protect the
battery from overcharging.
Please make sure that the charger cables have been properly connected and char-
ging is done in a well ventilated environment.
The charger should be used in a dry environment. Charger and cables must be pro-
tected from contact with water, because there is a risk of electric shock. Do not touch
the device with wet hands. If any error occurs while charging, disconnect the charger
from the power supply.
When disconnecting the charger from the power supply depends on the pull by the
plug, not the cord.
To Next Page
Loading...
Need help?
General
