Remote Control Manual - PS-81B / PS-101B
11
1
3
4
5
6
7
7
8
9
11
Features of remote control............................................................
Indicators on remote controller......................................................
Handling the remote controller.....................................................
Setting the clock...........................................................................
Automatic operation......................................................................
Cooling/Heating/Fan only operation..............................................
Drying operation ..........................................................................
Timer operation............................................................................
Example of timer setting...............................................................
Cautions.......................................................................................
CONTENTS
11
Cautions
1. When replacing batteries, do not use old batteries or different type
batteries. Otherwise it may cause the remote controller to malfunction.
2. If you do not use the remote controller for a few weeks or more, remove
the batteries. Otherwise, battery leakage may damage the remote
controller.
3. The average battery life during normal use is approximately half a year.
Replace the batteries when there is no receiving beep from the indoor
unit or if the transmission indicator on the remote controller fails to light.
4. Be sure there are no barriers between the remote controller and
the receiver of indoor unit otherwise the air conditioner will not
work.
5. Keep the Remote Controller away from all liquids.
6. Protect the Remote Controller from high temperatures and exposure
to radiation.
7. Keep the indoor receiver out of direct sunlight or the Air Conditioner
may malfunction.
8. Keep controller away from EMI (Electro-Magnetic Interference)
supplied by other household appliances.
Model
Transmission Distance
Lowest Voltage of
CPU Emitting Signal
Rated Voltage
R09D/BG(C)E,
8m
2.0V
Environment
Specification
。 。
O O
-5 C 60 C(-41 F~140 F)
~
R09E/BG(C)E, RG09E/BG(C)EU1,
R09F/BG(C)E, RG09D/BG(C)EU
3.0V(Dry batteries R03/LR03×2)
N
OTE:
Buttons design is based on typical model and might be slightly different
rom the actual one you purchased, the actual shape shall prevail.
All the functions described are accomplished by the unit. If your remote is
issing a referenced button, the corresponding function is not available.
When there are wide differences between Remote controller Illustration
nd USERS MANUAL on function description, the description on USERS
ANUAL shall prevail.
This device complies with all national regulations. In Canada,
t complies with CAN ICES-3(B)/NMB-3(B). In USA, this device
omplies with part 15 of the FCC Rules. Operation is subject to the
ollowing two conditions: (1) This device may not cause harmful interfe-
ence, and (2) this device must accept any interference received,
ncluding interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for
lass B digital device, pursuant to part 15 of the FCC Rules. These
imits are designed to provide reasonable protection against harmful
nterference in a residential installation. This equipment generates, uses
nd can radiate radio frequency energy and, if not installed and used in
ccordance with the instructions, may cause harmful interference to radio
ommunications. However, there is no guarantee that interference will
ot occur in a particular installation. If this equipment does cause harmful
nterference to radio or television reception, which can be determined by
urning the equipment off and on, the user is encouraged to try to correct
he interference by one or more of the following measures:
eorient or relocate the receiving antenna.
ncrease the separation between the equipment and receiver.
onnect the equipment into an outlet on a circuit different from that to
hich the receiver is connected.
onsult the dealer or an experienced radio/TV technician for help.
hanges or modifications not approved by the party responsible for
ompliance could void suers authority to operate the equipment.