Remote Control Manual - PS-81B / PS-101B
8
CLOCK
C
ON
O
FF
SET TEMP.
FAN SPEED
Indicators on remote controller
Transmission Indicator
Temp. display
Time display
Fan speed display
Sleep Display
Mode display
ON/OFF display
This transmission indicator lights when
remote controller transmits signals to the
indoor unit.
Displays the current operation mode. Including
AUTO( ), COOL( ), DRY( ), HEAT( )
(Not applicable to cooling only models), FAN
ONLY ( )and back to AUTO( ).
。
Displays the temperature setting (17 C/62 F
to 30 C/86 F）when you set the operating
mode to FAN ONLY, no temperature setting is
displayed.
Displayed by pressing the ON/OFF button.
Press the ON/OFF button again to remove.
The clock time is indicated only when no
AUTO-ON/OFF timer is set. When AUTO-
TIMER feature is operating, it displays the
AUTO-ON/OFF time. To check the current
time, press the CLOCK button, and the time
will display.
Indicate Timer on/off time(0 24 hours)
or clock time.
Displays the selected fan speed, AUTO
and three fan speed levels " " (LOW)
" " (MED) " " (HIGH)
will be indicated. Displays AUTO when the
operating mode is either AUTO or DRY.
Displayed by pressing the SLEEP button.
Press the SLEEP button again to remove.
Note:
All displays on the remote controller are
shown for illustration purposes only.
3
8
Timer operation
When you select the timer operation, the remote controller automatically
transmits the timer signal to the indoor unit at the specified time.
Therefore, keep the remote controller in a location from which it can
transmit the signal to the indoor unit properly.
The effective operation time set by remote controller is limited in 24 hours.
CAUTIONS
1. TIMER button
Press the TIMER button, the remote
displays 0.0 alongside either the TIMER
ON or TIMER OFF indicator, and will
flash.
2. TEMP/TIME button
Press to set the desired time.
Forward
Backward
Press or hold the forward or backward
button to change the Auto time by 0.5
hour increments, up to 10 hours, then
at 1 hour increments up to 24 hours.
The selected time will register in seconds
after setting.
3. After setting the timer for TIMER ON and
TIMER OFF, check the TIMER indicator
on the display panel of the unit is
illuminated.
4. Cancel button(CANCEL)
Press the CANCEL button to cancel
the timer setting.
Preform steps 1, 2 and 3 to change the
settings.
.
.
Canceling
Changing
.
.
AUTO
F
AUTO
AUTO
Lock Display
Displayed by pressing the LOCK button.
Press the LOCK button again to remove.
~
1
2
3
ON
OF F
SE T T EMP .
FAN SPE E D
MODE
SLEEP
LED
CLOCK
CANCEL
TIMER
FAN
RESET
LOCK
.
Note: Some models have no MED Fan
speed selection.
SWING
C
To Next Page
Loading...
Need help?
General
