Marshall Amplification JCM 200 DSL 401 User Manual

2
46
8
100
INPUT
CLN/OD
2
46
8
10
0
2
46
8
10
0
2
46
8
100
2
46
8
100
2
46
8
100
2
46
8
100
2
46
8
100
2
46
8
100
2
46
8
100
2
46
8
100
2
46
8
100
GAIN
TREBLE MIDDLE BASS
GAIN VOLUME TREBLE MIDDLE BASS FX MIX REVERB VOLUME
POWERSTANDBY
OFFOFF
ONON
DUAL SUPER LEAD
JCM 2000 - DSL 201
CLEAN OVERDRIVE MASTER
LOUDSPEAKER OUTPUT
20W into 16 Ω
SPEAKER EMULATED
D.I. OUT
CHANNEL
FOOTSWITCH
RETURN
FX LOOP
SEND
CAUTION!: TO REDUCE THE RISK OF FIRE REPLACE FUSES WITH THE SAME TYPE AND RATING ONLY. DISCONNECT SUPPLY CORD BEFORE
CHANGING FUSE. TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
ATTENTION!: POUR EVITER LES RISQUES D’INCENDIE UTILISER UN FUSIBLE DE MEME TYPE ET DE MEME CALIBRE. DEBRANCHER AVANT DE
REMPLACER LE FUSIBLE. POUR EVITER LES RISQUES DE DECHARGES ELECTRIQUES, NE PAS OUVRIR LE COUVERCLE. CET APPAREIL NE COMPORTE
AUCUNE PIECE SUSCEPTIBLE D’ETRE REPAREE PAR VOS SOINS. FAITES TOUJOURS APPEL A UN TECHNICIEN QUALIFIE POUR TOUTE REPARATION.
WARNING!:RISK OF HAZARDOUS ENERGY!
AVIS!:ENERGIE ELECTRIQUE DANGEREUSE!
HT FUSE
(T250mA)
MAINS FUSE
(T1A - 230V)
(T2A - 120V)
MAINS INPUT
120V ~ 60 Hz
100 Watts
Made in England by:
Marshall Amplification plc,
Bletchley, Milton Keynes, England.
WARNING!: SHOCK HAZARD. DO NOT OPEN. TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK
DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. THIS APPARATUS MUST BE EARTHED.
AVIS!: RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR. POUR EVITER LES RISQUES D’INCENDIE ET
DE DECHARGES ELECTRIQUES, N’EXPOSEZ JAMAIS CET APPAREIL A L’HUMIDITE OU A LA PLUIE.
CONNECTER CET APPAREIL A LA TERRE.
!
10 9 8 7 5 4 3 1
1 2 3 5 6 7 8 9 10 11 12
4
DSL201 Front Panel
DSL201 Rear Panel
DSL201 SPECIFICATIONS
Power Output - 20 Watts RMS into 16 ohms
Valve complement - 4 x ECC83/12AX7 and 2 x EL84
Loudspeaker Type - 12” 16 ohm 50 Watt Model SPKR-00072
Mains Requirement - Preset for 117V~60Hz or 230V~50Hz
Other variations to special order - see local distributor for information.
Mains Fuse - T2A - 117V or T1A - 230V
H.T. Fuse - T250mA
32 33

Marshall Amplification JCM 200 DSL 401 Specifications

General

Brand	Marshall Amplification
Model	JCM 200 DSL 401
Category	Amplifier
Language	English