en
►►1. INFORMATION
REGARDING SAFETY
IMPORTANT: READ AND
UNDERSTAND THIS
OPERATIONAL MANUAL BEFORE
ASSEMBLING, COMMISSIONING
OR PERFORMING MAINTENANCE
ON THIS APPLIANCE. INCORRECT
USE OF THE APPLIANCE CAN
CAUSE SERIOUS INJURY. KEEP
THIS MANUAL FOR FURTHER
REFERENCE.
IMPORTANT: This appliance is
not suitable for use by persons
(including children) with reduced
physical, sensory and mental
capacities or with lack of experience
or knowledge unless supervised
by a person responsible for their
safety. Children must be supervised
to make sure they do not play with
the appliance.
►1.1. Fill the appliance tank only
with clean water.
►1.2. Switch off and disconnect the
appliance from the mains before
lling it.
►1.3. Do not move the appliance,
once the tank has been lled.
►1.4. When using the appliance,
comply with all local regulations
and Standard in force.
►1.5. Keep the appliance dry, in
order to avoid electric shocks.
Hands must always be dry.
►1.6. Use only in ventilated and dry
areas.
►1.7. For indoor use only.
►1.8. Power the appliance only with
voltage and frequency as specied
on the data plate.
►1.9. Only use extensions with three
wires appropriately connected to
earth.
►1.10. Do not cover the appliance
with paper, cardboard, plastic,
metal sheets or any other
inammable material during use,
in order to prevent any risk.
►1.11. The appliance must be used
on a stable and levelled surface, in
order to prevent any risk.
►1.12. When it is not used,
disconnect the appliance from the
power plug.
►1.13. Do not block the air vent (rear
side) or the air outlet (front side) of
the appliance.
►1.14. The minimum safety distance
recommended between the
appliance and walls or other items
is 0,5 m.
►1.15. When the appliance is
connected to the mains or running,
it must never be moved, handled,
topped-up or subject to any
maintenance operation.
►1.16. The appliance (power cable
included) must be kept at a suitable
safety distance from heat sources.
►1.17. In any case, the appliance
must be opened and/or repaired by
authorised after-sales centre.
►1.18. If the power cable is
damaged, it must be replaced by
the technical after-sales centre, in
order to prevent any risk.
►1.19. Rinse the case with clean
water and clean it before using,
after the period during which the
bio cooler was not in use.
►1.20. In the case of improper
operation of the product at the
start, disconnect itfrom the power
supply immediately and contact
service point.
►1.21. Protect the power supply
cord from damage as a result
of movement of the vehicles or
Figures and texts of this book are protected by COPYRIGHT.
To Next Page
Loading...
Need help?
General
