To Next Page

To Previous Page

ASSEMBLY

125-OFR-A

1. Slide axle through Wheel Frame and attach wheels, washers and nuts (see Figure 6).

2. Place main structure on wheel frame and fasten with long screws provided (see Figure 7).

3. Attach safety guard to front of the heater with screws provided (see Figure 8).

4. Attach Radiant Visors to the top and bottom rear of the Radiant Cone Assembly using extra screws included.

5. Attach top safety guard using the two outer-most extra screws on the top of the radiant cone (see Figure 9).

Note: Save the box and packaging materials for future storage.

OPERATION

Fueling The Heater:

Kerosene

For optimal performance of this heater, it is strongly suggested that Kerosene be used. Kerosene has been refined to virtually eliminate contaminants, such as sulfur,

which can cause rotten egg odor during the operation of the heater. Using diesel fuel can cause excess soot production. Do not use Bio-Diesel as this fuel will damage

your heater’s seals nd filter. – CSA certified for use with K-1 kerosene, no. 1 & no. 2 diesel, JP8/Jet A Fuel, no. 1 and no. 2 fuel oil.

DANGER

NEVER REFUELS THIS HEATER WHILE IT IS HOT OR OPERATING. FIRE OR EXPLOSION COULD RESULT.

NEVER FILL THE FUEL TANK INDOORS.

CAUTION

ALWAYS FILLS THE TANK OUTDOORS. BE SURE THAT THE HEATER IS ON LEVEL GROUND WHEN FUELING, AND NEVER OVERFILL

THE TANK.

WARNING

DO NOT USE GASOLINE OR CRANKCASE DRAININGS.

– NEVER use fuel such as, benzene, alcohol, white gas, camp stove fuel, farm diesel, paint thinners, or other oil compounds in this heater. THESE ARE VOLATILE

FUELS HAT CAN CAUSE A FIRE OR EXPLOSION.

– NEVER store Kerosene in the living space. Kerosene should be stored in a well-ventilated area outside the living area.

– NEVER store Kerosene in direct sunlight or near a source of heat.

– NEVER use Kerosene that has been stored from one season to the next. Kerosene deteriorates over time. OLD Kerosene WILL NOT BURN PROPERLY