CORDED IMPACT WRENCH - 054-3182-0CORDED IMPACT WRENCH - 054-3182-0
13 14
PROBLEM POSSIBLE CAUSES SOLUTIONS
The impact wrench does not work The impact wrench is not plugged
into a power source
Plug the impact wrench into an
appropriate power source
Socket cannot be installed Improper socket selection Use a suitable socket
The motor is overheating Cooling vents are obstructed Clean and clear vents. Do not cover
with hand during operation
TROUBLESHOOTING
Before each use
1. Inspect the impact wrench, the On/Off switch, the cord and the accessories for damage.
2. Check for damaged, missing, or worn parts.
3. Check for loose screws, misalignment or binding of moving parts, or any other condition that may
affect the operation.
4. If abnormal vibration or noise occurs, turn the tool off immediately and have the problem corrected
before further use. Unplug the tool from the power source before cleaning or performing any
maintenance. Using compressed air may be the most effective cleaning method. Always wear
safety goggles when cleaning tools using compressed air.
WARNING!
Do not allow brake fluids, gasoline, petroleum-based products, penetrating oil, etc. to come
into contact with plastic parts. These substances contain chemicals that can damage,
weaken, or destroy plastic.
WARNING!
When servicing, use only identical replacement parts. The use of any other parts may
create a hazard or cause damage to the product.
WARNING!
If the supply cord is damaged, it must be replaced by a specially prepared cord available
through the service organization.
WARNING!
Use only accessories that are recommended for this impact wrench by the manufacturer.
Accessories that may be suitable for one tool may become hazardous when used with
another tool.
WARNING!
To ensure safety and reliability, all repairs should be performed by a qualified service
technician.
MAINTENANCE
To Next Page
Loading...
Need help?
General
