headline bars
continuation tabs
notes
warnings
13
headline bars
continuation tabs
notes
warnings
model no. 054-8363-0 | contact us 1.800.689.9928
12
No. Part No. Part
1 On/off trigger switch 8 Bevel adjustment locking knob
2 Auxiliary handle 9 Mounting slots for edge guide
3 Spindle-lock button 10 Edge-guide locking knob
4 Main handle 11 Depth scale
5 Lower blade guard 12 Depth-of-cut adjustment lever
6 Lower blade-guard lever 13 LED worklight
7 Bevel scale 14 Edge guide
IMPORTANT INFORMATION
Before attempting to use this tool, become familiar with all of its operating features and safety requirements.
For optimum performance and safety, read the following operating instructions carefully before using.
LED WORKLIGHT
(fig 1)
The LED worklight, located beside the spindle-lock button,
will illuminate when the circular saw is turned on. This
provides additional light on the surface of the workpiece
for operation in lower-light conditions.
The LED worklight turns on automatically when the tool is
plugged into a power source.
BLADE GUARD SYSTEM
(fig 2)
The lower blade guard attached to your circular saw is
there for your protection and safety. It should never be
altered for any reason. If it becomes damaged or begins
to return slowly or sluggishly, do not operate the saw
until the blade guard has been repaired or replaced.
Always leave the guard in its correct operating position
when using the saw.
WARNING!
• Do not allow familiarity with the circular saw to cause a lack of alertness. A fraction of a
second of carelessness is enough to cause severe injuy.
• Never connect the circular saw to the power source when you are assembling parts,
making adjustments, installing or removing cutting blade, cleaning, or when it is not in
use. Disconnecting the circular saw will prevent accidental starting, which could cause
serious personal injury.
• When using the saw, always stay alert and exercise control. Do not remove the saw from
the workpiece while the blade is moving.
DANGER!
• When sawing through a workpiece, the lower blade guard does not cover the blade
on the underside of the workpiece. Since the blade is exposed on the underside of the
workpiece, keep hands and fingers away from the cutting area. Any part of your body
coming in contact with a moving blade will result in serious injury.
CAUTION!
• Never use the saw when the guard is not operating properly. The guard should be
checked for correct operation before each use. If you drop your saw, check the lower
blade guard and bumper for damage at all depth settings before using.
KEY PARTS DIAGRAM
IMPORTANT INFORMATION
LED worklight
fig 1
fig 2
Lower blade guard is
in the up position when
making a cut
To Next Page
Loading...
Need help?
General
