MasterCraft Maximum 054-8146-8 User Manual

11
10
model no. 054-8146-8 | contact us 1.800.689.9928
IMPORTANT INFORMATION
Before attempting to use this reciprocating saw, become familiar with all of its
operating features and safety requirements.
This reciprocating saw features the ideal speed/stroke combination for efficient
cutting. For optimum performance and safety, read the following operating
instructions before using.
VARIABLE SPEED (g1)
The trigger switch delivers higher speed
with increased trigger pressure, and lower
speed with decreased trigger pressure.
LIVE TOOL INDICATOR (g2)
Your reciprocating saw has a “live tool
indicator” green light, located where
the power cord enters the handle. This
green light is always on when the saw is
plugged into a power source.
ASSEMBLY INSTRUCTIONS
INSTALLING A SAW BLADE (g3)
1. Disconnect the saw from the power
supply.
2. Open the blade-clamp lever.
3. Insert the saw blade into the blade
clamp as far as possible, and close the
blade clamp lever to lock the blade in
position.
REMOVING THE SAW BLADE (g3)
1. Disconnect the saw from the power supply.
2. Open the blade-clamp lever.
3. Remove the saw blade from the blade clamp.
BASE (SHOE) ASSEMBLY
SLIDING THE SHOE IN OR OUT(g4)
For maximum control and longer blade
life, the base assembly slides in or out to
adjust the effective stroke length.
1. Disconnect the saw from the power
supply.
2. Press the shoe-release button and slide
the shoe to the desired position. The
shoe can be locked in any position.
3. Release the shoe-release button to
lock the shoe in the desired position.
ASSEMBLY INSTRUCTIONS
WARNING!
• Make sure that the front end of the blade extends through the
footplate for the entire stroke length. Do not use specialty blades
that are very short or those with a significant cant. The blade must
not contact the footplate at any point in its stroke. A blade that is too
short or canted could jam inside the foot and snap.
FPO
IMPORTANT INFORMATION
WARNING!
• Do not allow familiarity with the reciprocating saw to cause a
lack of alertness. A fraction of second of carelessness is enough
to cause severe injury.
• If any part of the reciprocating saw is missing or damaged, do
not use the saw until the part has been repaired or replaced.
Failure to head this warning could result in serious injury.
• Always unplug the tool from the power source before making any
adjustment or attaching accessories.
• Always make sure the switch is “OFF” before plugging in.
FPO
g1
g3
g4
g2
Live tool
indicator

MasterCraft Maximum 054-8146-8 Specifications

General

Brand	MasterCraft
Model	Maximum 054-8146-8
Category	Saw
Language	English