21
CARE AND MAINTENANCE
HOW DO I CLEAN MY MACHINE?
Clean with soap and water cleaners only. Never use solvents on plastic parts. Cleanliness of your Climbmill and its operating
environment will keep maintenance problems and service calls to a minimum. For this reason, Customer Tech Support
recommends that the following preventive maintenance schedule be followed.
DAILY
Unplug the unit. Clean entire machine using water and a mild soap or other Matrix approved solution (cleaning agents
should be alcohol and ammonia free).
MONTHLY (C3x only)
Unplug the Climbmill and remove the access panel. Clean chain of old grease and
re-apply a lithium-based grease to each chain link.
QUARTERLY
Check step motion and stability to ensure the Climbmill does not rock or wobble.
Check all connecting joint areas for tightness of bolt assemblies.
Ensure that there is little, or no free play at all joint assemblies once bolts have
been tightened. Installation of washer kits may be required if free play does not
come out from tightening bolts.
Unplug the Climbmill and remove the access panel. Clean sprockets of old
grease and re-apply a lithium-based grease to sprocket teeth.
Unplug the Climbmill and clean the AUTO STOP SENSORS (located under the
bottom step) and IR sensor windows on Control Zone with a cotton swab and
rubbing alcohol.
For 7xe consoles, enter service mode and select ‘test’. Select ‘touch calibration’ and then select ‘start’. Follow the on-
screen prompts and touch the screen where indicated.
CONSOLE RESPONSIVENESS ISSUES (CONSOLE REBOOT):
FOR 7XE CONSOLES
Press and HOLD the Channel Up and Channel Down Button until you hear a Beep. Your console will reset.
AUTO STOP
SENSORS
To Next Page
Loading...
Need help?
General
