3
PROPER USAGE
1. Do not exceed weight limits of the exercise device.
2. If applicable, set safety stops to appropriate height.
3. If applicable, adjust seat pads, leg pads, foot pads, range of motion
adjustment, or any other type of adjustment mechanisms to a comfortable
start position. Make certain that the adjusting mechanism is fully
engaged to prevent unintentional movement and to avoid injury.
4. Sit on bench (if applicable) and get into appropriate position for exercise.
5. Exercise using no more weight than you can safely lift and control.
6. In a controlled manner, perform exercise.
7. Return weight to its fully-supported start position.
WARRANTY
For North America, please visit www.matrixtness.com for warranty
information along with warranty exclusions and limitations.
PRODUCT SPECIFICATIONS
Max User Weight 136 kg / 300 lbs.
Max Training Weight 93.4 kg / 207.5 lbs.
Product Weight 320 kg / 706 lbs.
Overall Dimensions
(L x W x H)*
148.5 x 117 x 135 cm /
58.4” x 46” x 53”
* Ensure a minimum clearance width of 0.6 meters (24”) for access to and
passage around MATRIX strength equipment. Please note, 0.91 meters (36”)
is the ADA recommended clearance width for individuals in wheelchairs.
MAINTENANCE CHECKLIST
ACTION FREQUENCY
Clean Upholstery
1
Daily
Inspect Cables
2
Daily
Clean Guide Rods Monthly
Inspect Hardware Monthly
Inspect Frame Bi-Annually
Clean Machine As Needed
Clean Grips
1
As Needed
Lubricate Guide Rods
3
As Needed
1
Upholstery & Grips should be cleaned with a mild soap
and water or a non-ammonia based cleaner.
2
Cables should be inspected for cracks or frays and immediately replaced if present.
If excessive slack exists cable should be tightened without lifting the head plate.
3
Guide rods should be lubricated with Teon based lubricant. Apply the
lubricant to a cotton cloth and then apply up and down the guide rods.
ENGLISH
TORQUE VALUES
M10 Bolt (Nyloc Nut & Flowdrill) 77 Nm / 57 ft -lbs
M8 Bolts 25 Nm / 18 ft-lbs
M8 Plastic 15 Nm / 11 ft-lbs
M6 Bolts 15 Nm / 11 ft-lbs
Pad Bolts 10 Nm / 7 ft-lbs
All manuals and user guides at all-guides.com
To Next Page
Loading...
Need help?
General
