14
ITALIANO
INFORMAZIONE
PROPER USAGE
1. Do not exceed weight limits of the exercise device.
2. If applicable, set safety stops to appropriate height.
3. If applicable, adjust seat pads, leg pads, foot pads, range of motion
adjustment, or any other type of adjustment mechanisms to a comfortable
start position. Make certain that the adjusting mechanism is fully
engaged to prevent unintentional movement and to avoid injury.
4. Sit on bench (if applicable) and get into appropriate position for exercise.
5. Exercise using no more weight than you can safely lift and control.
6. In a controlled manner, perform exercise.
7. Return weight to its fully-supported start position.
MAINTENANCE CHECKLIST
ACTION FREQUENCY
Clean Upholstery
1
Daily
Inspect Cables
2
Daily
Clean Guide Rods Monthly
Inspect Hardware Monthly
Inspect Frame Bi-Annually
Clean Machine As Needed
Clean Grips
1
As Needed
Lubricate Guide Rods
3
As Needed
1
Upholstery & Grips should be cleaned with a mild soap
and water or a non-ammonia based cleaner.
2
Cables should be inspected for cracks or frays and immediately replaced if present.
If excessive slack exists cable should be tightened without lifting the head plate.
3
Guide rods should be lubricated with Teflon based lubricant. Apply the
lubricant to a cotton cloth and then apply up and down the guide rods.
SPECIFICHE DEL PRODOTTO
Peso massimo dell’utente 159 kg / 350 lb
Peso massimo di stoccaggio 159 kg / 350 lb
Peso del prodotto 34 kg / 75 lb
Dimensioni totali (P x L x A)* 95 x 48 x 122,5 cm / 37,5” x 19” x 48,25”
* Verificare che vi sia uno spazio attorno all’attrezzatura isotonica MATRIX di
almeno 0,6 metri (24") per l’accesso e il passaggio. Da notare che lo spazio
raccomandato da ADA per gli utenti su sedia a rotelle è di 0,91 metri (36").
48 cm
(19”)
95 cm
(37,5”)
AREA LIBERA
0,6 m (2 piedi)
LARGHEZZA PASSAGGIO
AREA DI ALLENAMENTO
VALORI DI COPPIA
½ - 13” Bullone (Dado Nylock e foratura a flusso) 135 Nm / 100 piedi-lb
⅜ - 16” Bullone (Dado Nylock e foratura a flusso) 77 Nm / 57 piedi-lb
5
⁄
16
- 18” Bullone
25 Nm / 18 piedi-lb
5
⁄
16
- 18” Plastica
15 Nm / 11 piedi-lb
¼ - 20" Bullone 15 Nm / 11 piedi-lb
Bulloni cuscinetto 10 Nm / 7 piedi-lb
Descrizione Q.tà
A
B
C
D
¾” Chiave inglese
Bullone (½-13 x 4¼ Zinc)
Rondella (MB ⅞”x ½”, 18GA Zinc)
Rondella (⁷⁄
16
” Zinc)
Dado di nyloc (½-13)
2
2
2
2
2