12
conditions and do not store it outdoors.
Do not use the chainsaw in the vicinity of
ammable liquids or gases and in wet or humid
environments. Failure to do so may cause re or
explosion.
Work only in suitable light conditions.
You are responsible for the safety of your work
area.
Caution! Some tools / cutting tools have sharp
edges and tips. Be especially careful when
handling them and wear protective gloves to
protect yourself from injury!
Ensure a secure footing and wear non-slip, high-
heeled closed shoes.
Protect the device from rain and moisture.
When the engine is running, always hold the saw
rmly with both hands.
Use the claw as a starting point for each cut,
always start cutting with the saw chain running.
Make the cut so that the saw does not get stuck
in the wood.
Pay special attention to branches under tension.
Pull the device out of the wood only with a
running saw chain.
Never work above the shoulder level or with the
device with one hand.
Always stand outside the direction of fall.
Stay on slopes above the tree to be felled. Do
sawing work on a tree that stands on a slope,
always on the side, never from above or below.
Always pay attention to the fall direction of the
parts to be separated.
Never position the tip of the rail for cutting and
never saw with the rail's tip - risk of blowback!
- There is always danger of blowback, when the
tip of the rail touches wood or other objects.
The chain saw will become uncontrollable and
can be pushed with great force in the direction of
the operator.
Always saw through only one branch at a time.
When cutting to length, pay attention to adjacent
trunks.
Do not use the appliance as a lever to move
objects.
Always use the chain guard during transport and
storage.
Secure the device during transport to avoid fuel
loss, damage or injury.
Warning!
Keep passers-by away from the running device,
but never work alone.
Stay within earshot of others if you need help.
Stop the engine immediately when someone
approaches you.
Make sure that the saw chain does not come
into contact with foreign objects such as stones,
fences, nails or similar objects. These objects
could be ung out, injuring the user or the
person passing by or damage the saw chain.
National regulations may restrict the use of the
device.
Do not use the machine in any position from
which it may come within the radius of 10 m of
high-voltage power lines.
For an adequate protective equipment during
the use, care must be taken in accordance with
the operating instructions. All other usages are
ruled out. Any damage or injury resulting from
misuse is the responsibility of the user / operator
and not the manufacturer. Use only 3-teeth
blades suitable for the machine as mentioned in
the operating instructions.
To Next Page
Loading...
Need help?
General
