44
3. Make sure that the blade cover is overlaid
before storing or transporting the unit.
1
A48
1). Gearbox turned to the storage / transport
position
Safe use
The device is designed for cutting hedges.
Do not use the device for any other purpose. Do
not try to cut through stone, metal, plastic or
other hard objects.
Use of the hedge trimmer for other purposes
may result in personal injury or serious personal
injury.
Preparation:
• Wear suitable protective clothing and protective
gear; see section "Safety instructions".
• Select the working position, which is most
suitable to protect you from falling objects
(branches, etc.).
• Start the engine.
• Put on the belt.
Never stand directly under the branch you wish
to cut. Watch out for falling branches. Remember
that a branch can spring back on the ground
after the fall.
Working position:
Hold the control lever with your right hand and
the shaft with your left hand. Your left arm should
be stretched out in a comfortable position.
Caution: Rest, when you feel exhausted.
Applications
Preparations
Use pruning shears to remove thick branches
rst.
Cutting sequence
If a round cut is necessary, perform the cut in
several steps.
Cutting techniques
Vertical cut:
Move the blade up and down in a curve at the
hedge. Use both sides of the blade.
Horizontal cut:
Hold the blade at an angle of 0 ° to 10 ° and move
the hedge trimmer in a horizontal direction.
Move the blade in an arc to the edge of the
hedge so that the waste falls to the ground.
A49
Horizontal cut
Cut close to the ground in a standing position, e.g.
low bushes A 19.
A50
To Next Page
Loading...
Need help?
General
