Matrix PETROL 4-IN-1 User Manual

17
- Fix the cutting guard (15) with the screws
to the holder on the shaft (if not already
mounted). In addition, the protective
cover with knife must be attached to the
protective cover for the cutting edges.
- Lock the shaft of the brush cutter at the
intended place with a screwdriver or with
the provided Allen key (21).
- Using the spark plug wrench (22), loosen
the locking nut for the blade (16) by
turning it clockwise (if already mounted).
- Remove the locking nut (20), the
clamping ange (18) and the holding plate
(19) for the thicket knife. Keep these parts
safe.
- Leave the support ange (17) on the
shaft.
- Lock the shaft of the brush cutter at the
intended place with a screwdriver or with
the provided Allen key (21).
- Turn the thread spool (14) counter-
clockwise onto the shaft.
CAUTION: Left-hand thread
Connecting the drive unit and assembly:
Insert the ends of the assemblies to be
connected. Make sure that the locking
pin (26) locks in place. Check pulling apart
on a trial and error basis. Fold down the
cover (26a) and secure the assemblies by
tightening the locking screw (12).
Release of drive unit and assembly:
Loosen the locking screw (12). The cover
(26a) jumps back. Hold the locking pin (26)
pressed underneath the cover and loosen
the modules by carefully pulling them
apart simultaneously.
A7
12
26a
26
16

Matrix PETROL 4-IN-1 Specifications

General

Brand	Matrix
Model	PETROL 4-IN-1
Category	Lawn and Garden Equipment
Language	English