8
CAUTION Fire hazard!
Petrol and petrol fumes are highly ammable!
The waste oil must be disposed of in accordance
with the applicable regulations.
Do not smoke while you refuel or
operate the device.
Dry up any spilled petrol immediately.
Start the device only at a location away from the
refuelling point.
Make sure that the lid of the tank is always tightly
closed. Pay attention to possible leaks.
While the engine is running or when the engine
is hot, do not open the fuel cap or rell fuel.
Open the tank cap slowly, so that petrol fumes
can escape.
Make sure the handles are dry, clean, and free of
petrol mixture.
Do not use the device without exhaust and
properly installed exhaust protection.
Do not touch the exhaust. Danger of burns.
Use only the fuel recommended in the manual.
Store petrol only in designated containers in a
safe place.
Caution! Petrol and oil may leak if used
incorrectly, stored improperly or if there
is a damage. Take precautions to prevent
environmental damage in such a case. For
example, oil and petrol can be absorbed with
special binders.
In case of re, use CO2 extinguishers to smother
the re. Foam, powder or sand are also suitable
for extinguishing small res. Never extinguish
petrol and oil res with water. Risk of explosion!
In case of emergency, contact your re
department!
Always stand below the cutting tool when
cutting on the slope.
Always make sure that there are no objects or
similar things accumulate in the cord head in the
protective hood or in. the engine.
Do not use wire or the like in the thread spool.
Work only in daylight or under good articial
lighting.
Before each use, check the device and its
components and protective devices for damage
or wear and, if necessary, carry out the necessary
repairs. Never put devices of protection and
safety out of operation. Do not use the device , if
damage or signs of wear and tear have become
apparent.
Keep the tools clean and functional, in order to
be able to work better and safer..
Always keep the device away from the body
when working.
Always switch o the device during breaks from
work and relocations, wait for the cutting tool to
stop and switch o the engine.
Never leave the device unattended at the
workplace. Store the device in a safe place during
work interruptions.
Do not be distracted while working with this
device. Through that, you could lose control of
the tool.
Never use the device in rainy, humid or wet
conditions and do not store it outdoors.
If the device gets wet, wait for it to dry
completely before using it again.
Locate and remove foreign objects from the
workspace before working with this equipment. If
you still encounter a foreign object while cutting,
turn o the device nd remove it.