11
vibrations, if the device is used for a longer period
or if it is not properly handled or maintained.
2. Injuries and property damage caused by
spinning tool attachments that are unexpectedly
thrown out of the machine due to sudden
damage, wear, or improper attachment.
3. For an adequate protective equipment during
the use, care must be taken in accordance with
the operating instructions. All other usages are
ruled out. Any damage or injury resulting from
misuse is the responsibility of the user / operator
and not the manufacturer. Use only 3-teeth
blades suitable for the machine as mentioned in
the operating instructions.
Frequent use of vibrating devices may cause
nerve damage to persons whose blood
circulation is compromised (e.g., smokers,
persons with diabetics).
If you notice any unusual disturbances, stop
working immediately and consult a doctor.
Observe the following instructions to reduce the
risks:
1. Keep your body, especially your hands, warm
in cool weather.
2. Take regular breaks, moving your hands to
increase blood ow.
3. Keep changing work positions egularly to
avoid a one-sided load on the body and to
prevent health damage.
Make sure that the device vibrates as little as
possible by ensuring regular maintenance and by
xed parts on the device.
Do not smoke while you refuel or operate the
device.
Wipe up any spilled fuel immediately.
Examine the device for any leaks.
Do not use the device if you nd any leaks.
While the engine is running or if the engine is
hot, do not open the fuel cap and do not rell
fuel.
Do not touch the exhaust. Danger of burns.
Use only the fuel recommended in the manual.
Store petrol only in designated containers in a
safe place.
Always switch o the device before putting it
away.
Work only in daylight or under good articial
lighting.
Carry out a visual inspection of the device before
each use.
Check if all screws and connecting parts are tight.
Always hold the device rmly with both hands.
Before each use, check the device and its
components and protective devices for damage
or wear and, if necessary, carry out the necessary
repairs. Never put protection and safety devices
out of operation. Do not use the device if damage
or signs of wear and tear have become apparent.
Keep the tools clean and functional, in order to
be able to work better and safer.
Always keep the device away from the body
when working.
Always switch o the device completely during
work interruptions and relocation, wait for the
chain saw to stop and put on the chain guard.
Never leave the device unattended at the
workplace. Store the device in a safe place during
work interruptions.
Do not be distracted while operating the device.
If you are distracted you could lose control of the
device.
Never use the device in rainy, humid or wet
To Next Page
Loading...
Need help?
General
