Matrix S-DRIVE PERFORMANCE TRAINER User Manual

4
SERIAL NUMBER LOCATION
ASSEMBLY
UNPACKING
Unpacktheequipmentwhereyouwillbeusingit.Placethecartononalevelatsurface.Itis
recommendedthatyouplaceaprotectivecoveringonyouroor.Neveropenboxwhenitisonitsside.
IMPORTANT NOTES
During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded.
Several parts have been pre-lubricated to aid in assembly and usage. Please do not wipe
thisoff.Ifyouhavediculty,alightapplicationoflithiumgreaseisrecommended.
SERIAL NUMBER
MODEL NAME: S-DRIVE PERFORMANCE TRAINER
* Use the information above when calling for service.
TOOLS REQUIRED:
F 8mm T-Wrench
F 5mm Allen Wrench
F 6mm Allen Wrench
F 8mm Wrench x2
F 10mm Wrench x2
F Phillips Screwdriver
PARTS INCLUDED:
F 1 Base Frame
F 2 Front Handlebar Supports
F 2 Rear Handlebar Supports
F 1 Sled Bar
F 1 Handlebar Set
F 1 Harness
F 1 Hardware Kit
WARNING!
There are several areas during the assembly process that special attention must be
paid. It is very important to follow the assembly instructions correctly and to make
sureallpartsarermlytightened.Iftheassemblyinstructionsarenotfollowed
correctly, the equipment could have parts that are not tightened and will seem
loose and may cause irritating noises. To prevent damage to the equipment, the
assembly instructions must be reviewed and corrective actions should be taken.
NEED HELP?
If you have questions or if there are any missing parts, contact Customer
Tech Support. Contact information is located on the information card.
ENGLISH

Matrix S-DRIVE PERFORMANCE TRAINER Specifications

General

Brand	Matrix
Model	S-DRIVE PERFORMANCE TRAINER
Category	Treadmill
Language	English