26
ASSEMBLY STEP 1
A Cut the yellow banding straps and lift the running
deck upward to remove all contents from underneath
the running deck.
B Open hardware bag 1.
C Slide main frame boot up console mast.
Place right console mast over main frame
bracket.
D Pull lead wire through right console mast.
After pulling the lead wire through the mast, the
top of the console cable should be located at
the top of the mast. Detach and discard lead wire.
NOTE: Do not pinch console cable when
placing the mast onto the main frame bracket.
E Attach console mast to main frame
bracket using 3 bolts (a), 3 spring
washers (b) and 3 arc washers (c).
F Slide main frame boot down over main frame
bracket.
G Repeat steps D–F on other side.
NOTE: Do not tighten bolts until step 3 is complete.
To Next Page
Loading...
Need help?
General
