15
4.6 ASSEMBLY STEPS R1x
REAR FOOT
1) Install the rear foot in position at the rear of the bike with the mating
holes in the frame bracket. Insert the four screws (Z04) through the frame
bracket and rear foot. Using the #5 Allen Wrench (Z32) tighten the
screws securely.
PEDALS
1) Install the pedals on the pedal cranks using the Open Wrench (Z31). The
Matrix logo on the pedal strap must point upward. NOTE: Be careful to
align the threads correctly to avoid damage. A little grease on the threads
should help the pedals to screw in easily and correctly. Turn the left pedal
spindle counter clockwise when threading into the crank arm, and turn
the right pedal spindle clockwise when threading into the crank arm.
Z04
STEP 1
1) Pull the heart rate wire through the hole in the bottom of the seat frame,
and make sure the wire get through the tunnel of the plate. Mount the
seat handlebars to the seat frame by using three socket-flat-head screws
(Z05).
To Next Page
Loading...
Need help?
General
