66
12) Plug the coax cable into the coax adaptor attached to the back half of the console (Figure M).
13) Use the 4 screws removed in Step 4 to re-attach the 2 halves of the console. NOTE: Route the TV power, coax, and controller wiring
through the hole in top of the console. Also make sure that the console cable wires are protruding so that they are accessible (Figure N).
14) Install the bracket to the console using 4 screws (Figure O).
15) Install the console back onto the console mast and secure it with 5 screws (Figure P). NOTE: Make sure to tuck all the wiring into the
console or mast to prevent any pinching.
16) Install the TV onto the bracket making sure that the tabs on the TV lower plastic shield fit into the slots in back of the console (Figure Q),
and secure the TV to the bracket with 4 screws (Figure R).
10.5 TV BRACKET INSTALLATION - CONTINUED
FIGURE RFIGURE Q
FIGURE PFIGURE O
FIGURE NFIGURE M
CHAPTER 10: BIKE SPECIFICATIONS AND ASSEMBLY GUIDE
To Next Page
Loading...
Need help?
General
