9
HYBRID CYCLE ASSEMBLY
There are several areas during the assembly process to which special attention
must be paid. It is very important to follow the assembly instructions correctly and to
make sure all parts are firmly tightened. If the assembly instructions are not followed
correctly, the unit could have parts that are not tightened, possibly leading to a loose fit
or and will seem loose and may cause irritating noises. To prevent damage to the unit,
the assembly instructions must be reviewed and corrective actions should be taken.
Before proceeding, find your unit’s frame serial number located on the front stabilizer
tube as shown. The console serial number is located on a barcode sticker on the
console, near the connection between the console and the mast. The model name of
your product is determined by the combination of the console series (example: 3X)
and the frame type (example: Hybrid Cycle).
ENTER YOUR SERIAL NUMBERS AND MODEL NAME IN THE BOXES BELOW:
» Use the information above for initial setup and when calling for service.
WARNING
FRAME SERIAL NUMBER:
CONSOLE SERIAL NUMBER:
MODEL NAME:
MATRIX
CONSOLE SERIAL NUMBER LOCATION
FRAME SERIAL NUMBER LOCATION
To Next Page
Loading...
Need help?
General
