43
CARE AND MAINTENANCE
WHAT KIND OF ROUTINE MAINTENANCE IS REQUIRED?
We use sealed bearings throughout our bikes so lubrication is not needed. The most important maintenance step is to simply
wipe your perspiration off the bike after each use.
HOW DO I CLEAN MY MACHINE?
Clean with soap and water cleaners only. Never use solvents on plastic parts. Cleanliness of your unit and its operating
environment will keep maintenance problems and service calls to a minimum. For this reason, Customer Tech Support
recommends that the following preventive maintenance schedule be followed.
DAILY
• Unplug the unit. Clean entire machine using water and a mild soap or
other Matrix approved solution (cleaning agents should be alcohol and
ammonia free).
• Inspect the power cord. If the power cord is damaged, contact Customer
Tech Support.
• Make sure the power cord is not underneath the unit or in any other area
where it can become pinched or cut during storage or use.
WEEKLY
Clean underneath the bike, following these steps:
• Turn off the bike.
• Move the bike to a remote location.
• Wipe or vacuum any dust particles or other objects
that may have accumulated underneath the bike.
• Return the bike to its previous position.
MONTHLY
• Inspect all assembly bolts and pedals on the
machine for proper tightness.
• Clean any debris off of the seat guide rail.
QUARTERLY
• For 7xe consoles, enter service mode and select ‘test’. Select ‘touch
calibration’ and then select ‘start’. Follow the on-screen prompts and
touch the screen where indicated.
To remove power from the exercise
bike, the power cord must be
disconnected from the wall outlet.
WARNING
CONSOLE RESPONSIVENESS
ISSUES (CONSOLE REBOOT):
FOR 7XE CONSOLES:
Press and HOLD the Channel Up and
Channel Down Button until you hear a Beep.
Your console will reset.
To Next Page
Loading...
Need help?
General
