Maytronics Atlantis User Manual

Table of Contents
I. Tools needed for repair Page 3
II. Testing and replacing main components Page 4
– Analyze power supply Page 4
– Analyze cable Page 5
– Replace motor unit Page 10
III. Replacing brushes
Page 15
III. Replacing brushes
Page 15
IV. Replacing tracks Page 21
V. Replacing filter bags Page 25
2
*NOTE: Some images may differ slightly in shape, color, etc.

Maytronics Atlantis Specifications

General

Brand	Maytronics
Model	Atlantis
Category	Swimming Pool Cleaners
Language	English

Summary

Tools for Dolphin Atlantis Repair

Dolphin Atlantis Testing Procedures

Analyze Dolphin Power Supply

Test power supply functionality using a Dolphin tester; a green light confirms it is working.

Analyze Dolphin Atlantis Cable

Remove robot cover, disconnect cable, and test using Dolphin tester and power supply.

Replace Dolphin Motor Unit

Remove screws, disconnect cable, and replace the motor unit if other components test functional.

Dolphin Atlantis Brush Replacement

Remove Old Brush

Loosen and pry the brush from the tracks to start the removal process.

Replace Brush Parts

Remove and replace brush components like spacer, shaft, bearings, and rings.

Install New Brush

Center the new brush axle and snap it into the tracks until it clicks.

Dolphin Atlantis Track Replacement

Remove Side Panel and Track

Detach side panel by removing screws, then remove and replace the track.

Install New Track

Wind track around center gear, using longer track on the guide wheel side.

Dolphin Atlantis Filter Bag Maintenance

Access and Remove Filter Bag

Turn unit over, slide clips, remove lid, then detach bag from frame.

Secure Filter Bag

Ensure elastic band is fully down over the bottom plate lip when reinstalling bag.