126
Controls in detail
Memory function
Prior to operating the vehicle, the driver
should check and adjust the seat height,
seat position fore and aft, and seat back-
rest angle if necessary, to ensure adequate
control, reach and comfort. The head re-
straint should also be adjusted for proper
height. See also the section on air bags
(
컄 page 68) for proper seat positioning.
In addition, adjust the steering wheel to
ensure adequate control, reach, operation
and comfort. Both the interior and exterior
rear view mirrors should be adjusted for
adequate rear vision.
Fasten seat belts. Infants and small chil-
dren should be seated in a properly se-
cured restraint system that complies with
U.S. Federal Motor Vehicle Safety Stan-
dard 213 and Canadian Motor Vehicle
Safety Standard 213.
With the memory switch you can store up
to three different settings.
The following settings are stored when us-
ing the buttons on the driver’s door:
앫 Driver’s seat and backrest position
ì•« Steering wheel position
앫 Driver’s side exterior rear view mirror
position
ì•« Passenger side exterior rear view mir-
ror position
The following settings are stored when us-
ing the buttons on the passenger door:
ì•« Passenger seat and backrest position
The memory switch is located on the door
control panel.
M Memory button
1, 2, 3 Stored positions
왘 Switch on the ignition (컄 page 39).
or
왘 Open the respective door.
Warning! G
Do not activate the memory function on the
driver’s side while driving. Activating the
memory function while driving could cause
the driver to lose control of the vehicle.
To Next Page
Loading...
Need help?
General
