50
Getting started
Driving
1 Seat belt housing
2 Latch plate
3 Buckle
4 Release button
왘 With a smooth motion, pull the belt
from seat belt housing 1.
왘 Place the shoulder portion of the belt
across the top of your shoulder and the
lap portion across your hips.
왘 Push latch plate 2 into buckle 3 until
it clicks.
왘 If necessary, tighten the lap portion to
a snug fit by pulling shoulder portion
up.
왘 To release the seat belt, press release
button 4 and guide latch plate back to
seat belt housing 1.
Warning! G
Never let more people ride in the vehicle
than there are seat belts available. Be sure
everyone riding in the vehicle is correctly re-
strained with a separate seat belt. Never use
a seat belt for more than one person at a
time.
Warning! G
Never ride in a moving vehicle with the seat
backrest in an excessively reclined position
as this can be dangerous. You could slide
under the seat belt in a collision. If you slide
under it, the belt would apply force at the ab-
domen or neck. That could cause serious or
even fatal injuries. The seat backrest and
seat belt provide the best restraint when the
wearer is in a nearly upright position and the
belt is properly positioned on the body.
Warning! G
Read and observe the additional warning no-
tices in the “Safety and Security” section
(
컄 page 77).
To Next Page
Loading...
Need help?
General
