58
Getting started
Driving
Single wipe
왘 Press the combination switch briefly in
direction of arrow 2 to the resistance
point.
The windshield wipers wipe one time
without washer fluid.
Wiping with windshield washer fluid
왘 Push the combination switch in direc-
tion of arrow 2 past the resistance
point.
The windshield wipers operate with
washer fluid.
For information on filling up the washer
reservoir, see “Windshield washer system
and headlamp cleaning system”
(
컄 page 282).
i
Intermittent wiping is interrupted when the
vehicle is at a standstill and a front door is
opened. This protects persons getting into or out
of the vehicle from being sprayed.
Intermittent wiping will be continued when
앫 all doors are closed and the gear selector
lever is in position D or R
or
앫 the wiper setting is changed using the com-
bination switch
i
To prevent smears on the windshield, wipe
with windshield washer fluid every now and then
even when it is raining.
!
If anything blocks the windshield wipers
(leaves, snow, etc.), switch them off immediate-
ly.
앫 For safety reasons, stop the vehicle in a safe
location and
앫 remove the SmartKey from the starter
switch
or
앫 turn off the engine by pressing the
KEYLESS-GO* start/stop button and
open the driver’s door (with the driver’s
door open, the starter switch is in posi-
tion 0, same as with the SmartKey re-
moved from the starter switch)
before attempting to remove any blockage.
앫 Remove blockage.
앫 Turn the windshield wipers on again.
If the windshield wipers fail to function at all in
switch position I,
앫 set the combination switch to the next high-
er wiper speed
앫 have the windshield wipers checked at the
nearest authorized Mercedes-Benz Center
컄컄
To Next Page
Loading...
Need help?
General
