The supplementary cushion is located in the
vehicle.
The supplementary cushion is attached to the
head restraint by three press studs.
Installing the supplementary cushion:
X
Position the head restraint as far forwards as
possible (
Y page 107).
X
Hold supplementary cushion ; against the
head restraint and push press studs : into
the counterpieces.
Removing the supplementary cushion:
X
Position the head restraint as far forwards as
possible (
Y page 107).
X
Release press studs : and remove supple-
mentary cushion ;.
Adjusting the rear center head
restraints
Retracting and extending electrically
X
Press and hold button : until the head
restraint has fully extended or retracted.
Folding into position mechanically
X
Pull the head restraint up until it engages.
Adjusting the multicontour seat
The settings for the multicontour seat are only
activated if:
R
the seat is occupied
R
the seat belt is fastened
The multicontour seat can be adjusted via the
multimedia system (see the separate operating
instructions).
Adjusting the active multicontour
seat
The settings for the active multicontour seat are
only activated if:
R
the seat is occupied
R
the seat belt is fastened
Vehicles installed with the Seat Comfort
package: you can adjust the active multicon-
tour seat for the driver and front passenger via
the multimedia system (see the separate oper-
ating instructions).
Multicontour seat in the rear
You can adjust the multicontour seats for the
outer seats using the remote control (see the
separate operating instructions).
Seats
117
Seats, steering wheel and mirrors
Z
To Next Page
Loading...
Need help?
General
