tion of aftermarket radio frequency transmitting
equipment") when retrofitting RF transmitters.
Comply with the legal requirements for add-on
parts.
If your vehicle has fittings for two-way radio
equipment, use the power supply or aerial con-
nections intended for use with the basic fittings.
Be sure to observe the manufacturer's addi-
tional instructions when installing.
Deviations in respect of wavebands, maximum
transmission outputs or aerial positions must be
approved by Mercedes-Benz.
The maximum transmission output (PEAK) at the
base of the aerial must not exceed the following
values:
Waveband Maximum
transmission
output
Short wave
3–54 MHz
100 W
4 m waveband
74 - 88 MHz
30 W
2 m waveband
144–174 MHz
50 W
Trunked radio/Tetra
380–460 MHz
10 W
70 cm waveband
400–460 MHz
35 W
Mobile communications
(2G/3G/4G)
10 W
The following can be used in the vehicle without
restrictions:
R
RF transmitters with a maximum transmis-
sion output of up to 100 mW
R
RF transmitters with transmitter frequencies
in the 380 - 410 MHz waveband and a maxi-
mum transmission output of up to 2 W
(trunked radio/Tetra)
R
Mobile phones (2G/3G/4G)
There are no restrictions when positioning the
aerial on the outside of the vehicle for the fol-
lowing wavebands:
R
Trunked radio/Tetra
R
70 cm waveband
R
2G/3G/4G
Identification plates
Vehicle identification plate with vehi-
cle identification number (VIN)
X
Open the front right-hand door.
You will see the vehicle identification
plate :.
Vehicle identification plate (example: vehicles with
a trailer tow hitch)
:
Vehicle manufacturer (Daimler AG)
;
EU type approval number (for certain coun-
tries only)
=
VIN
?
Maximum gross vehicle weight (kg)
A
Maximum gross weight of vehicle combina-
tion (kg) (for certain countries only)
B
Permissible front axle load (kg)
C
Permissible rear axle load (kg)
D
Paint code
Identification plates
351
Technical data
Z
To Next Page
Loading...
Need help?
General
