R
Observe the notes on sockets: (/ page 109)
#
Press the start/stop button once to switch
on the power supply. (/ page 132)
#
Press On/Off switch 4 on the tire inflation
compressor to I.
The tire inflation compressor is switched on.
The tire is inflated. The tire pressure is
shown on manometer 5.
#
Pump the tire to the specified tire pressure.
%
The specified tire pressure is stated on the
label of the emergency spare wheel.
#
When the specified tire pressure has been
reached, press on and off switch 4 on the
tire inflation compressor to 0.
The tire inflation compressor is switched off.
#
Press the start/stop button to switch off the
power supply.
#
If the tire pressure is higher than the speci‐
fied pressure, press pressure release valve
button 6 until the correct tire pressure has
been reached.
#
Unscrew union nut 2 of filler hose 1 from
the valve.
#
Screw the valve cap of the emergency spare
wheel onto the valve again.
#
Store filler hose 1 and plug 3 in the lower
section of the tire inflation compressor hous‐
ing.
#
Store the tire inflation compressor in the
vehicle.
Wheels and tires
295
To Next Page
Loading...
Need help?
General
