The Adaptive Highbeam Assist automatically
switches between the following types of light:
R
Low beam
R
High beam
At speeds greater than 19 mph (30 km/h):
R
If no other road users are detected, the high
beam will be switched on automatically.
The high beam switches off automatically in the
following cases:
R
At speeds below 16 mph (25 km/h).
R
If other road users are detected.
R
If street lighting is sufficient.
At speeds greater than approximately 31 mph
(50 km/h):
R
The headlamp range of the low beam is regu‐
lated automatically based on the distance to
other road users.
The system's optical sensor is located behind
the windshield near the overhead control panel.
Switching Adaptive Highbeam Assist on/off
#
To switch on: turn the light switch to
the à position.
#
Switch on the high beam using the combina‐
tion switch.
When the high beam is switched on automat‐
ically in the dark, the _ indicator lamp on
the multifunction display will light up.
#
To switch off: switch off the high beam
using the combination switch.
Setting the exterior lighting switch-off delay
time
Requirements:
R
The light switch is in the à position.
Multimedia system:
4
©
5
Settings
5
Light
5
Exterior Lighting Delay
#
Set the switch-off delay time.
When the vehicle engine is switched off, the
exterior lighting will be activated for the set
time.
Switching the surround lighting on/off
Multimedia system:
4
©
5
Settings
5
Light
5
Locator Lighting
When Locator Lighting is active, the exterior
lighting lights up for 40 seconds after the vehicle
is unlocked. When you start the vehicle, the sur‐
round lighting is deactivated and the automatic
driving lights are activated.
118
Light and visibility
To Next Page
Loading...
Need help?
General
