a - Special washer head bolt (10-849838)
b - Flat washer (2)
c - Nylon insert locknut (11-826709113)
d - Nylon insert locknut (11-826709113)
Description Nm lb. in. lb. ft.
Special washer head bolt 27 20
Nylon insert locknut "d" 27 20
Nylon insert locknut "c" Tighten until seats, then back off 1/4 turn
Assemble steering link rod to steering cable with two flat washers and self-locking nylon insert locknut. Tighten
locknut until it seats, then back nut off 1/4 turn.
Assemble steering link rod to engine with special washer head bolt and self-locking nylon insert locknut. First torque
bolt, then torque locknut to specifications.
Fuse Replacement
MODELS WITH CARBURETORS
IMPORTANT: Always carry spare 20 and 30 AMP fuses.
The electrical wiring circuits on the outboard are protected from overload by fuses in the wiring. If a fuse is blown,
try to locate and correct the cause of the overload. If the cause is not found, the fuse may blow again.
1. Open the fuse holder and look at the silver colored band inside the fuse. If band is broken, replace the fuse.
Replace fuse with a new fuse with the same rating.
To Next Page
Loading...
Need help?
General