MAINTENANCE
37
!
WARNING
Disengagement of a steering link rod can result in the boat taking a full, sudden, sharp turn. This
potentially violent action can cause occupants to be thrown overboard exposing them to serious injury
or death.
ob00676
a
b
c
d
a - Special washer head bolt (10-849838)
b - Flat washer (2)
c - Nylon insert locknut (11-826709113)
d - Nylon insert locknut (11-826709113)
Description Nm lb. in. lb. ft.
Special washer head bolt 27 20
Nylon insert locknut "d" 27 20
Nylon insert locknut "c" Tighten until seats, then back off 1/4 turn
Assemble steering link rod to steering cable with two flat washers and self-locking nylon insert locknut.
Tighten locknut until it seats, then back nut off 1/4 turn.
Assemble steering link rod to engine with special washer head bolt and self-locking nylon insert locknut.
First torque bolt, then torque locknut to specifications.
Fuse Replacement
IMPORTANT: Always carry spare 5 and 20 AMP fuses.
The electrical wiring circuits on the outboard are protected from overload by fuses in the wiring. If a fuse
is blown, try to locate and correct the cause of the overload. If the cause is not found, the fuse may blow
again.
To Next Page
Loading...
Need help?
General
