221
%
*
[RE03900(ALL)03/95]
Removing jumper cables
*
[RE04000(ALL)03/95]
1. Always remove the jumper cables in the
reverse order. Remove the negative (s) end
of the jumper cable from the metallic surface
on the engine or frame of the disabled
vehicle.
*
[RE04100(ALL)03/95]
2. Remove the negative (s) cable from the
booster battery.
*
[RE04200(ALL)03/95]
3. Remove the positive (+) cable from the
booster battery.
*
[RE04300(ALL)03/95]
4. Remove the other end of the positive (+)
cable from the discharged battery.
*
[RE04400(ALL)04/95]
After the vehicle is started, let it idle for a while
to let the engine “relearn” its idle conditions.
Drive it around for a while with all electrical
accessories turned off to let the battery recharge.
You may need to use a battery charger to fully
recharge the battery.
*
[RE04450(ALL)03/95]
If you need to replace your battery, see Battery
in the Servicing Your Vehicle chapter.
%
*
[RE04500(ALL)03/95] Changing a Tire
*
[RE04600(ALL)01/95]
If you get a flat tire while you are driving, do
not apply the brake heavily. Instead, gradually
decrease the speed. Hold the steering wheel
firmly and slowly move to a safe place on the
side of the road. Park on a level spot, turn off
the ignition, set the parking brake, and turn on
the hazard flashers.
[RE04610(ALL)01/95]
NOTE: Tire sealants that are injected through
the valve stem are not to be used to
service punctured tires because they
can produce wheel rust and tire
imbalance.
File:fcres.ex
Update:Tue Aug 8 11:02:29 1995
To Next Page
Loading...
Need help?
General
