Safety belt maintenance
Inspect the safety belt systems periodically to make sure they work
properly and are not damaged. Inspect the safety belts to make sure
there are no nicks, wears or cuts, replacing if necessary. All safety belt
assemblies, including retractors, buckles, front seat belt buckle
assemblies (slide bar)(if equipped), shoulder belt height adjusters
(if equipped), child safety seat tether bracket assemblies (if equipped),
and attaching hardware, should be inspected after a collision. Ford
recommends that all safety belt assemblies used in vehicles involved in a
collision be replaced. However, if the collision was minor and a qualified
technician finds that the belts do not show damage and continue to
operate properly, they do not need to be replaced. Safety belt assemblies
not in use during a collision should also be inspected and replaced if
either damage or improper operation is noted.
Failure to inspect and if necessary replace the safety belt
assembly under the above conditions could result in severe
personal injuries in the event of a collision.
Refer to Cleaning and maintaining the safety belts in the
Maintenance and care section.
AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
0
1
2
3
4
5
6
H
C
F
E
OFF
OFF
REW
1
FF
2
SIDE 1-2
3
FM 1
VOL – PUSH ON
AM
FM
BASSTREB
BAL FADE
AUTO
SET
CLK
SEEK
TUNE
DISCS
SCAN
4
DOLBY SYSTEM
EJ
TAPE CD
COMP
5
SHUFFLE
6
PUSH
20
10
30
40
50
60
70
80
90
110
200
000000
oooo
100
20
40
60
80
100
120
140
160
180
UNLEADED
FUEL ONLY
OD
ON/OFF
H
H
L
OFF ON
R. WIPE
• A/C
• MAX
A/C
RSM
SET
ACC
COAST
OFF
ON
SRS
Seating and safety restraints
125
To Next Page
Loading...
Need help?
General
