GENERAL INFORMATION
22
Lanyard Stop Switch
The purpose of a lanyard stop switch is to turn off the engine when
the operator moves far enough away from the operator's position
(as in accidental ejection from the operator's position) to activate
the switch. A lanyard stop switch can be installed as an accessory -
generally on the dashboard or side adjacent to the operator's
position.
While activation of the lanyard stop switch will stop the engine
immediately, a boat will continue to coast for some distance
depending upon the velocity and degree of any turn at shut down.
However, the boat will not complete a full circle. While the boat is
coasting, it can cause injury to anyone in the boat's path as
seriously as the boat would when under power.
a - Lanyard cord b - Lanyard stop switch
We strongly recommend that other occupants be instructed on
proper starting and operating procedures should they be required
to operate the engine in an emergency (e.g. if the operator is
accidentally ejected).
!
WARNING
Should the operator fall out of the boat, the possibility of serious
injury or death from being run over by the boat can be greatly
reduced by stopping the engine immediately. Always properly
connect both ends of the stop switch lanyard to the stop switch
and the operator.
To Next Page
Need help?
General
