MAINTENANCE
75
2. Make sure the bottom rubber seal fits properly and lock the
front and rear latches.
Battery Inspection
The battery should be inspected at periodic intervals to ensure
proper engine starting capability.
IMPORTANT: Read the safety and maintenance instructions
which accompany your battery.
1. Turn off the engine before servicing the battery.
2. Make sure the battery is secure against movement.
3. Battery cable terminals should be clean, tight, and correctly
installed. Positive to positive and negative to negative.
4. Make sure the battery is equipped with a nonconductive shield
to prevent accidental shorting of battery terminals.
Fuel System
!
WARNING
Fuel is flammable and explosive. Ensure the key switch is off and
the lanyard is positioned so that the engine cannot start. Do not
smoke or allow sources of spark or open flame in the area while
servicing. Keep the work area well ventilated and avoid
prolonged exposure to vapors. Always check for leaks before
attempting to start the engine and wipe up any spilled fuel
immediately.
Before servicing any part of the fuel system, stop engine and
disconnect the battery. Drain the fuel system completely. Use an
approved container to collect and store fuel. Wipe up any spillage
immediately. Material used to contain spillage must be disposed
of in an approved receptacle. Any fuel system service must be
performed in a well‑ventilated area. Inspect any completed service
work for sign of fuel leakage.
FUEL LINE FILTER
Inspect the fuel line filter. If the filter appears to be contaminated,
remove and replace.
To Next Page
Loading...
Need help?
General
