IMPORTANT: Do not run engine above idle when flushing.
4. Adjust water flow (if necessary) so excess water continues leaking out
from around the rubber cups to ensure the engine is receiving an
adequate supply of cooling water.
5. Check for a steady stream of water flowing out of the water pump
indicator hole. Continue flushing the outboard for 3 to 5 minutes, carefully
monitoring water supply at all times.
6. Stop the engine, turn off the water, and remove the flushing attachment.
Reinstall the propeller.
Top Cowl Removal and Installation
REMOVAL
1. Unlock the rear latch by pushing lever down.
2. Lift rear of cowl and disengage front hook.
INSTALLATION
1. Engage the front hook and push cowl back over the cowl seal.
2. Push cowl down and move the rear latch lever up to lock.
MAINTENANCE
eng 51
To Next Page
Loading...
Need help?
General
