MAINTENANCE
eng 81
2. Fasten filter cover with three screws.
Alternator Belt Inspection
!
WARNING
Inspecting the belts with the engine running may cause serious
injury or death. Turn off the engine and remove the ignition key
before adjusting tension or inspecting belts.
1. Inspect the alternator belt and have it replaced by an
authorized dealer if any of the following conditions are
found.
a. Cracks or deterioration in the rubber portion of the belt.
b. Belt surfaces rough or uneven.
c. Signs of wear on edges or outer surfaces of belt.
Lubrication Points
1. Lubricate the following with Quicksilver or Mercury Precision
Lubricants Anti‑Corrosion Grease or 2‑4‑C with PTFE.
Tube
Ref No.
Description Where Used Part No.
94
Anti-Corrosion
Grease
Propeller shaft 92-802867Q 1
95
2-4-C with
PTFE
Propeller shaft 92-802859A 1
To Next Page
Loading...
Need help?
General
