7. Do not advance the neutral fast idle speed feature on the remote control
for starting.
8. Turn the ignition key to "START" position. Release the key when engine
starts. If engine fails to start in 10 seconds, return the key to "OFF"
position, wait one second and try again.
NOTE: The electronic starting system will automatically prime (choke) the
engine and increase idle speed for starting.
9. Check for a steady stream of water flowing out of the water pump
indicator hole.
IMPORTANT: If no water is coming out of the water pump indicator hole, stop
the engine and check cooling water intake holes for obstruction. No
obstruction may indicate a water pump failure or blockage in the cooling
system. This condition will cause the engine to overheat. Have the outboard
checked by your dealer. Operating the engine while overheated will cause
engine damage.
Gear Shifting
IMPORTANT: Observe the following:
•
Never shift the outboard into gear unless the engine speed is at idle.
•
Do not shift the outboard into reverse when the engine is not
running.
• Your outboard has three gear shift positions to provide operation: forward
(F), neutral (N), and reverse (R).
OPERATION
eng 63
To Next Page
Loading...
Need help?
General
