INSTRODUCTION:
Thank you for choosing Mercury AMD series distribution amplifier. It is designed to amplify weak
FM/DAB/TV aerial from antenna and distribute to multiple outputs, ideal for domestic or commercial
use to distribute FM/DAB/TV/Sat signal to different room/area.
PRODUCT FEATURE:
- Separate dedicated inputs for VHF and UHF signal.
- Built in low noise high gain amplifier to boost weak signals from antenna.
- Built in mixer to give wide band VHF and UHF output.
- Built 4G filter to prevent interference from 4G mobile signal.
- Full max gain output to for further signal distribution installation.
- DC pass function allows installation for additional infra-red control for satellite receiver.
- Short circuit protection as well as surge and spike protection to ensure your TV/Hi-Fi is
protected from lightning strike.
SPECIFICATION:
INSTALLATION:
Before install please ensure all devices to be connecting to the amplifier are switched off and
disconnected to the mains. The unit is designed to be connected via coax connector, f type adaptors
are supplied allows compatibility. At the back of the case there are two mount holes which allow unit
to be mounted on the wall.
AMD distribution amplifier is designed to amplify weak signal and distribute to different destination.
For installation that is close to TV transmitter or any other form of radio transmitter or high power
source, may experience blocking or frozen picture screen. An attenuator will require tuning down
signal to suitable level for TV viewing.
To Next Page
Loading...
Need help?
General
