Mercury LP2500 User Manual

Mercury Security © 2018 LP2500 DOC 10107-0063 REV 1.02 Page 2
Jumpers and Jacks:
The LP2500 controller hardware interface is configured using jumpers to setup the port interface and end of line
termination.
JUMPERS
SET AT
DESCRIPTION
J1
N/A
10-BaseT/100Base-TX Ethernet port
J2
N/A
Factory use only
J3
N/A
Factory use only
J4
OFF
Port 1 RS-485 EOL terminator is off
ON
Port 1 RS-485 EOL terminator is on
J5
OFF
Port 2 RS-485 EOL terminator is off
ON
Port 2 RS-485 EOL terminator is on
J6
N/A
microSD Card
J7
N/A
USB Port (2.0)
DIP Switches:
The four switches on S1 DIP switch are used to configure the operating mode of the LP2500 controller. DIP
switches are read on power-up except where noted. Pressing reset switch S2 causes the LP2500 to reboot.
1
2
3
4
Definitions
OFF
OFF
OFF
OFF
Normal operating mode.
ON
X
OFF
OFF
After initialization, enable default User Name (admin) and Password
(password). The switch is read on the fly, no need to reboot.
See IT security section for additional information
OFF
ON
OFF
OFF
Use factory default communication parameters.
ON
ON
OFF
OFF
Use OEM default communication parameters. Contact system
manufacture for details. See Bulk Erase below.
ON
ON
OFF
OFF
Bulk Erase prompt mode at power up. See Bulk Erase below.
X
X
X
ON
Makes the LP2500 report and function like an EP2500. To be used in
situations where the host software has not been updated to support
the LP series product line.
All other switch settings are unassigned and reserved for future use. X = don’t care.
In the factory or OEM default modes, downloaded configuration/database is not saved to flash memory.
Factory Default Communication Parameters:
Interface 1 (NIC1)
Network: static IP address: 192.168.0.251
Subnet Mask: 255.255.0.0
Default Gateway: 192.168.0.1
DNS Server: 192.168.0.1
Primary Host port: IP server, TLS if Available, port 3001, communication address: 0
Alternate Host Port: Disabled
4. Bulk Erase Configuration Memory:
The bulk erase function can be used for the following purposes:
 Erase all configuration and cardholder database (sanitize board, less third party applications)
 Update OEM default parameters after OEM code has been changed
 Recover from database corruption causing LP2500 board to continuously reboot
If clearing the memory does not correct the initialization problem, contact technical support.

Mercury LP2500 Specifications

General

Brand	Mercury
Model	LP2500
Category	Controller
Language	English