Section 5 - Maintenance
Page 54 90-8M0099741 eng JUNE 2015
1. Remove oil fill cap.
V-drive model shown
In-line dive model shown
2. Add the specified engine oil to bring the level up to, but not over, the FULL or OK range mark on the dipstick. Check the oil
level.
3. Replace the fill cap.
All Models
Capacity Fluid Type
Engine oil (with filter) 4.7 L (5 US qt) Mercury/Quicksilver 25W‑40 Synthetic Blend Engine Oil, NMMA FC‑W
Engine Oil Drain Pump
1. Loosen the oil filter to vent the system.
2. Remove the dipstick.
3. Install the oil pump onto the dipstick tube.
a - Oil pump
b - Dipstick tube
c - Oil drain hose
4. Insert the hose end of the crankcase oil pump onto an appropriate container and use the handle to pump until the
crankcase is empty.
5. Remove the pump.
6. Install the dipstick.
mc70571-1
a
c
b
To Next Page
Loading...
Need help?
General