OUTBOARD INSTALLATION
98
NOTE: For more accurate torque, whenever possible turn/tighten
the mounting locknuts rather than turning the mounting bolts.
3729
a
b
c
d
e
a - Flat washer (4)
b - 1/2 in. diameter bolt
(4)
c - Shank of bolt
d - Flat washer (4)
e - Locknut (4)
Description Nm lb. in. lb. ft.
Outboard mounting locknuts and
bolts
75 55
Electrical, Fuel Hose, Flush Hose and Control
Cables
FRONT COWL GROMMET
NOTE: Sufficient slack must exist in wiring, battery cables, and
hose, that are routed between the grommet and engine attachment
points, to relieve stress and prevent hoses from being kinked or
pinched.
To Next Page
Loading...
Need help?
General
